The Handy comes as a kit with the following items:
- Handy Data Card Holder
- 1 Pen
- 1 Data Card
- 10 alcohol pads
- instruction sheet
HDC Concepts "Handy" Data Card Holder
The data card holder can be used for the following:
- Shooting data
- Fieldcraft sketches
- GPS units (mounting)
- Electronic Dope cards
- Call Signs
- Radio Frequencies
- Notes/teaching information
- Land Navigation information
Instructions for use
This kit uses a permanent (but erasable) marker to insure that your information will be there when you need it! This kit includes alcohol wipes to remove the marker ink. The ink should not wipe off otherwise. Sweat and rain will not remove the ink. Once the ink has quickly dried your information will be prominently displayed on the card.
Using the same hand that you use to adjust your scope turrets, slide the hand through the wrist strap and place the pointer and middle fingers through the bungee cord.
Once this is done adjust both the bungee cord and wrist strap. It is recommended that the Handy Data Card Holder not be over tightened.
The Handy can be worn on either side of the forearms. To do this, loosen the bungee cord, slide the hand through the bungee cord in the direction of the wrist strap. Once the Handy is on your forearm, decide if you want to use on the outside/inside of the forearms. Then adjust both the wrist strap (around the wrist) and the bungee (around the forearm). These adjustments do not need to be overly tight.